Graham Slee Jazz Club



Bringing New Life to Old Records
– and modern records too!

The Jazz Club phono preamp will put new life into the sound of your old records: 78s; early vinyl LPs and EPs.

It does so by restoring their original tonal balance – something a modern phono preamp cannot do.

It also has the correct tonal settings (RIAA) for newer records meaning you only need this phono preamp for all your record collection.

The Jazz Club is supplied with the PSU1 power supply and is fitted with a rear panel mono-switch. Plus you’ll get an Old Record EQ information sheet, and more information on old record EQ can be found here.

Jazz Club phono preamp rear panel

Rear panel showing the mono switch

PSU1 power supply

The PSU1 power supply

The Jazz Club stereo phono preamplifier stage is a “legacy product” superseded by the Revelation phono preamplifiers. It was intended to be retired along with the Era Gold V phono preamp upon which the Jazz Club is based. However, public demand for both these phono preamps is still high and we therefore continue to manufacture and support them.

Using The Jazz Club Archival Phono Preamp

As well as being a hi-fi turntable preamp, the Jazz Club features settings to equalise pre-RIAA records. This means you can enjoy all your records – not just old ones – because the Jazz Club stereo turntable preamp is a great sounding hi-fi turntable preamplifier!

After connecting it up to your turntable, amplifier and/or recording equipment, and plugging the power supply in, you will then need to set the switches to suit the record you’re playing.

By setting the switches to their RIAA positions a modern stereo vinyl LP will be played with the correct EQ, and will give the right tonal balance.

When playing an older record you need to note its record label (its manufacturer’s name), and look up the settings given in the information sheet EQ tables.

We selected an old Brunswick 78 rpm shellac record and using a turntable equipped with a 78 rpm setting, consulted the EQ tables.

The recommended switch positions are “out – out – 500”, so the two leftmost switches were set to their mid “out” positions, and the right-hand switch set to 500 (which also happens to be the RIAA bass EQ setting).

You can see a pictorial representation of the resulting EQ curve here, and you’ll notice it’s a lot different to the RIAA curve which modern records are EQ’d to.

Brunswick EQ Curve

Brunswick EQ Curve



We also set the mono switch to mono which by summing left and right channels reduced the swishing sound. This effect is because the record centre was slightly eccentric and each revolution swung the stereo stylus side to side.

The results were much different to what the RIAA settings would give, and the music sounded a lot more realistic with a proper tonal balance to it.


All stereo high output cartridges (moving magnet; high output moving coil; high output moving iron) can be used with the Jazz Club stereo turntable preamplifier, but you may wish to use a dedicated mono cartridge instead.

This requires a slightly more specialized setting up procedure: It is best to use a true mono cartridge with a single output and connect it to only one of the stereo inputs. The unused input should be shorted using a shorting plug (contact us for this). The mono switch should be switched up or down (not used in its centre off position) and that will place the mono signal on both outputs.


Item Measurement
Input range 2mV to 10mV
Output (for input range) 252mV to 1,260mV (1.26V)
Maximum input 39mV rms
Maximum output 4.914V rms
Gain 42dB (126) at 1kHz
Input impedance 47k Ohms plus 100pf
Output (driving/source) impedance 1.2k Ohm
Recommended load impedance 10k Ohm or greater
Noise at output -65dB CCIR Q-pk
Distortion 0.02%
EQ curve accuracy < 0.5dB
Channel balance 0.2dB
Channel separation 64dB
Size (approx.) W: 107 x H: 50 x D: 180 (mm) inc. jacks