The Elevator EXP will give you hum-free sound, purer bass, greater definition and much more of your music.
In the beginning you’d buy a step up transformer (S.U.T.) to be able to use a moving coil cartridge. But they hummed and did weird things to the bass. The Elevator EXP changes all that.
The Elevator EXP is supplied with the PSU1 power supply, and a choice of voltages and power plugs.
Make Your MM Stereo Phono Amp Do Moving Coil
The Elevator EXP is designed to step-up the tiny moving coil signal to the moving magnet level of a hi-fi phono amp input.
It Also Let’s You Adjust To Taste
Whereas some moving coil cartridges will happily give their best with 100 Ω loading, others can be quite particular.
Rather than fiddling around with links or DIP switches, the Elevator EXP gives you all its loading options up front, right there on the front panel – making it easy to get your sound right.
Low output moving coil (MC) with output in the region of 0.15 – 0.8 mV (ref 1kHz at 5cm/sec)
The Elevator EXP must always be used between cartridge and a moving magnet sensitivity input. It must never be used ‘post EQ’ – after the moving magnet phono preamp.
|Input range||0.15mV to 0.8mV|
|Output (for input range)||2mV to 10mV, suitable for a moving magnet phono stage input|
|Maximum input||378mV rms (a very large overload margin)|
|Maximum output||4.914V rms|
|Gain||22dB (13) < 10Hz to 917kHz (-3dB points)|
|Input impedance||23, 30, 100, 840, 1000, 5100 and 47000 Ohms|
|Output (driving/source) impedance||300 Ohm|
|Recommended load impedance||47k Ohms phono stage preamp input|
|Noise at output||-99dB CCIR Q-pk|
|Frequency response||< 10Hz to 917kHz (-3dB points)|
|Size (approx.)||W: 107 x H: 50 x D: 180 (mm) inc. jacks|